3
A
1
23408
BASIC SETTINGS FOR THE TWINE WRAP
DEVICE
Setting up the knotter shaft and needles
3
PLEASE NOTE!
All settings for the knotter should be
made without baler twine threaded into the machine.
Setting the lateral stops of the needles on the knotter
frame:
Set up the needles ( 1) on the needle brackets, align
to the centre of the needle slot and screw tight.
The bolt torque of the hexagonal bolts (2)
M
10 = 45 Nm
Trigger the tying cycle using the control terminal, or
mechanically by pushing forward the cam (N) at the
control lever (S).
(Fig. 1 and 2)
QUADRANT 2 2 00 / 2 2 00 RC
Basic settings for the twine wrap device
1
1.7 / 1
