Basic settings for the twine wrap device
1.7 / 2
3
Turn the flywheel
by hand
in the direction of the
arrow.
The lateral stop of the needles when entering the
knotter must have an excess distance (X) of from
2 to 4 mm. This means that the needles will lie tight
against the knotter frames.
If necessary, loosen the bolts ( 2) and move the
needles laterally as required.
(Fig. 1 and 3)
Adjusting the height of the needles:
Release the tying cycle. Turn the flywheel
by hand
in
the direction of the arrow until the needle pulleys are
over the corners of the clamping plates ( 5). Check the
distance (C) between the lower edge of the needle to
the upper edge of the clamping plates with the gauge
(E). It must be 5_ 3 mm, see detail (V).
Loosen the three bolts ( 6) and then adjust the setting
with the bolts ( 7).
Bolt torque for the hexagonal bolts
4
M 12 DIN 9 3 1- 10.9 = 110 Nm.
(Fig. 1 and 4)
QUADRANT 2 2 00 / 2 2 00 RC
