Set the top dead centre of the needles:
Set both needle drawbars ( 3) to the
same length
and
adjust them so that the distance, dimension
(A),
is
about
78
9 mm.
R
elease the t
y
in
g
c
y
cle and turn the fl
y
wheel
by
hand
in the direction of the arrow until the needles
are standin
g
at the top dead centre position. In this
position the needle drawbars ( 3) and the crank arms
( 4) should lie parallel to and over one another. Check
the distance (B) from the rear ed
g
e of the clampin
g
plate ( 5) to the centre of the needle pulle
y
s with the
g
au
g
e (E). This distance must be from 9 5 to 100 mm,
see detail
(W).
If necessar
y
, adjust the len
g
th of the needle drawbars
in order to correct the settin
g
.
(Fi
g
. 1 and 5)
QUADRANT 2200 / 2200 RC
Basic settings for the twine wrap device
1.7 / 3
