Cisco Webex Room Panorama, Installation Manual

Page: 48 / 88

46
20.2 Mount a joining module on top of the lower corner panel
Repeat the procedure on both sides.
1. Fasten the vertical profile (
3203 #1
) with two
screws
(M4x12, Torx 20)
.
2. Add two screws with spacers
(M4x12, Torx 20;
Nylon spacer, 5 mm)
.
Add spacers to
these screws.
4. Place the joining module onto the corner
panel.
Make sure to fit the module fully into the
groove of the panel on all sides. Check
that the screws with spacers enter the
corresponding slots at the rear side of the
panel.
3. Fasten the two horizontal profiles (
3201 #3
) with
two screws
(M4x12, Torx 20)
each.
Note that two screws have spacers
(Nylon spacer, 5 mm)
.
Add spacers to
these screws.
Do not tighten
this screw now.
5. Fasten the module with two screws
(M4x12, Torx 20)
.
Only tighten the one at front.