Uncheck
Password Complexity
to disable the password security rules. However, we strongly recommend
keeping the password security rules enabled. For more information about passwords, see
.
Note
Step 13
Click
Next
. The
Configure Radio 1 - Name Your Wireless Network
window appears.
Step 14
Enter a
Network Name
. This name serves as the SSID for the default wireless network.
Step 15
Click
Next
. The
Configure Radio 1 - Secure Your Wireless Network
window appears.
Step 16
Choose a security encryption type and enter a security key. For a description of these options, see
Step 17
Click
Next
. The
Configure Radio 1 - Assign the VLAN ID for your Wireless Network
window appears.
Step 18
Choose the
VLAN ID
for traffic received on the wireless network.
We recommend that you assign a different VLAN ID from the default (1) to the wireless traffic, in order to segregate
it from the management traffic on VLAN 1.
Step 19
Click
Next
. Repeat the step 13 to step 18 to configure the settings for Radio 2 interface.
Step 20
Click
Next
. The
Enable Captive Portal - Create Your Guest Network
window appears.
Step 21
Select whether or not to set up an authentication method for guests on your network, and click
Next
.
If you click
No
, skip to Step 29.
If you click
Yes
, the
Enable Captive Portal - Name Your Guest Network
window appears.
Step 22
Specify a
Guest Network Name
.
Step 23
Click
Next
. The
Enable Captive Portal - Secure Your Guest Network
window appears.
Step 24
Choose a security encryption type for the guest network and enter a security key. For a description of these options,
see
Configuring Security Settings, on page 53
.
Step 25
Click
Next
. The
Enable Captive Portal - Assign the VLAN ID
window appears.
Step 26
Specify a
VLAN ID
for the guest network. The guest network VLAN ID should be different from the management
VLAN ID.
Step 27
Click
Next
. The
Enable Captive Portal - Enable Redirect URL
window appears.
Step 28
Check
Enable Redirect URL
and enter a fully qualified domain name (FQDN) or IP address in the
Redirect URL
field (including https://). If specified, the guest network users are redirected to the specified URL after authenticating.
Step 29
Click
Next
. The
Summary - Confirm Your Settings
window appears.
Step 30
Review the settings that you configured. Click
Back
to reconfigure one or more settings. If you click
Cancel
, all settings
are returned to the previous or default values.
Step 31
If they are correct, click
Submit
. Your setup settings are saved and a confirmation window appears.
Step 32
Click
Finish
.
The WAP device was configured successfully. You are required to log in again with the new password.
Using the Access Point Setup Wizard with Mobile
The first time that you log into the Access Point with your portable device or after it has been reset to the
factory default setting, the Access Point Setup Wizard with mobile style appears. This helps you perform the
initial configurations. To configure the Access Point using the wizard, complete the following steps:
Cisco WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN Administration Guide
4
Getting Started
Using the Access Point Setup Wizard with Mobile
Summary of Contents for Wap581
Page 4: ......
