12-4
Cisco TelePresence System 3200
OL-14521-01
Chapter 12 Field-Replaceable Unit Guide
Replacing a Plasma Display—Part Number CTS-DISP-65-GEN2
Step 7
Reattach the Ethernet and signal cables according to your temporary markings.
Do not attach the camera hoods at this time.
Step 8
Power on the system by completing the steps in the
“Powering On the System” section on page 12-1
.
Step 9
Perform the camera adjustment procedure and, if required, refocus and realign the camera.
See the
“Setting Up the Cameras” section on page 10-6
for more information.
Step 10
Re-attach the camera hood and lens hood.
Replacing a Plasma Display—Part Number CTS-DISP-65-GEN2
Required Information, Tools, and Equipment
To replace a display, you need the following information, tools, and equipment:
•
Release Notes for Cisco TelePresence System, Release 1.4
, OL-12074-05
•
Cisco TelePresence System Release 1.4 Administrator’s Guide
, OL-13676-03
Uncrating and unpacking:
•
Claw hammer or small pry bar
•
Large Phillips screwdriver
•
* Tin snips
•
* Pallet jack or hand cart (for moving components)
•
* Safety gloves
•
* Safety glasses
•
* Box cutters
Cisco TelePresence 3200 Structure, Accessory, and Adjustment Assembly:
•
Power screwdriver with 2.5, 3, and 6 mm (standard or round) Allen bits, or standard 2.5, 3, and 6 mm
Allen wrenches
Tip
A round-head Allen bit allows the bit to work at an angle instead of only straight out, which is
helpful in tight spots.
•
Manual screwdrivers, Phillips and flat head types
•
Metric wrenches, 10 to 15 mm
•
9/64-inch Allen wrench (supplied with speakers)
•
0.9mm Allen wrench for camera lens adjustments (if the lens uses a thumbscrew no tools are
required)
•
Level
•
Masking tape
•
* Tie wraps
