B-2
Cisco SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-07
Appendix B CLI Commands to Verify a Successful Installation
Basic Post-Installation Checklist
Complete command sequence for a fully-populated SCE 2000 platform using both the SM and the QM
SCE>enable 5
Password:<cisco>
SCE>
show version
SCE>
show interface GigabitEthernet 0/1
SCE>
show interface GigabitEthernet 0/2
SCE>
show interface GigabitEthernet 0/3
SCE>
show interface GigabitEthernet 0/4
SCE>
show system operation-status
SCE>
show interface linecard 0
SCE>
show interface linecard 0 connection-mode
SCE>
show interface linecard 0 link mode
SCE>
show rdr-formatter
SCE>
show interface linecard 0 subscriber sm-connection-failure
SCE>
show ip rpc-adapter sessions
connection mode
show interface linecard
connection-mode
Make sure that both the connection mode and the failure mode
are configured correctly.
link mode
show interface linecard link mode
When connection-mode is inline, link mode should be
configured to
forwarding
.
RDR formatter
Verify the following:
•
The RDR formatter has established a connection with the
configured destinations
•
The redundancy status is configured correctly in case of
more then one destination.
connection to Quota
Manager
show interface linecard subscriber
If using SM: Verify that the connection with the SM is
established.
connection to Quota
Manager
If using QM: Verify that the connection with the QM is
established.
To check this:
Use this command:
Comments
