B-5
Cisco SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-07
Appendix B CLI Commands to Verify a Successful Installation
Basic Post-Installation Checklist
show interface linecard link mode
sce>
show interface LineCard 0 link mode
Link mode on GBE1-GBE2
Current link mode is : forwarding
Actual link mode on active is : forwarding
Actual link mode on failure is: crosspath-bypass
Link mode on GBE3-GBE4
Current link mode is : forwarding
Actual link mode on active is : forwarding
Actual link mode on failure is: crosspath-bypass
show RDR-formatter
Look for:
•
Forwarding mode
•
Status (in Status column in the Connection Table)
sce>
show RDR-formatter
Status: enabled
Connection is: up
Forwarding mode: redundancy
Connection Table:
--------------------------------------------------------------------------------
| Collector | Port |
Status
| Priority per Category: |
| IP-Address / | | |------------------------------------------------|
| Host-Name | | | Category1 | Category2 | Category3 | Category4 |
|---------------|-------|------|-----------|------------|-----------|-----------|
| 10.240.59.39 | 33000 |
up
|100 primary| --- | --- | --- |
| 10.240.59.44 | 33000 |
up
| --- |100 primary | --- | --- |
---------------------------------------------------------------------------------
RDR: queued: 0 ,sent:60108106, thrown: 0, format-mismatch: 0
UM: queued: 0 ,sent: 0, thrown: 0
Logger: queued: 0 ,sent: 0, thrown: 0
Errors: thrown: 0
Last time these counters were cleared: 07:36:52 EDT TUE April 28 2009
show interface linecard subscriber sm-connection-failure
If working with the Subscriber Manager, use this command to make sure the connection with the SM is
established
SCE>
show interface linecard 0 subscriber sm-connection-failure
Current SM link state: up.
Configured action to take when SM link is down: No action.
Changing of system operational-status to 'warning' when SM link is down: enabled.
show ip rpc-adapter sessions
If working with the Quota Manager, use this command to make sure the connection with the QM is
established
sce>
show ip rpc-adapter sessions
client-name=usr.SM
client-address=/10.240.59.36
started=Mon Apr 06 12:43:01 GMT-04:00 2009
received-message-num=408790
sent-message-num=237292
