1-16
Cisco RF Gateway 10 Hardware Installation Guide
OL-16264-04
Chapter 1 Overview
Cisco RFGW-10 Components
Supervisor Engine Components
The following connectors, LEDs, and buttons are located on the front panel of the supervisor engine:
•
The STATUS LED, which indicates the operating state of the module
•
Two Gigabit uplink ports
•
Four SFP Gigabit uplinks ports
•
Eight utilization indicator LEDs, which provide an approximation of the current traffic across the
backplane
•
A console port (RJ-45)
•
An Ethernet management port (RJ-45)
•
A link status LED, which provides status for the management port
•
The Reset button (recessed), which allows you to reset the system
•
The Compact Flash port and eject button
Supervisor Engine LEDs
describes the meaning of the Supervisor Engine LEDs.
Table 1-7
Supervisor Engine LEDs
Ethernet Management Port
The supervisor engine has a 10/100 BASE-T Ethernet management port. The Supervisor engine uses an
RJ-45 connector on the front panel with a link status LED.
LED Status
Meaning
STATUS
Green
All diagnostic tests passed.
Red
A test failed.
Orange
System boot or diagnostic test is in progress.
Off
Supervisor is disabled.
UTILIZATION
Green 1-100%
If the switch is operational, this display indicates the current
traffic load over the backplane (as an approximate
percentage). Each LED lit green indicates approximately
12.5% of the load.
LINK
Green
The link is operational.
Orange
The link is disabled by user.
Flashing orange
The power-on self-test indicates a faulty port.
Off
No signal is detected or there is a link configuration failure.
Active
Green
The port is active.
Off
The port is not active.
