6-24
Cisco RF Gateway 10 Hardware Installation Guide
OL-16264-04
Chapter 6 Cabling the Cisco RFGW-10 UEQAM
Cabling the Supervisor Engine
Removing the 10-Gigabit Ethernet X2 Transceiver
Caution
The 10-Gigabit Ethernet X2 transceiver is a static-sensitive device. Always use an ESD wrist-strap or
similar individual grounding device when handling X2 transceivers or coming into contact with
modules.
If you are removing a 10-Gigabit Ethernet X2 transceiver, follow these steps:
Step 1
Disconnect the network fiber-optic cable from the 10-Gigabit Ethernet X2 transceiver connectors.
Immediately re-install the dust plugs in the X2 transceiver optical bores and the fiber-optic cable SC
connectors.
Step 2
Grip the sides of the 10-Gigabit Ethernet X2 transceiver sleeve with your thumb and forefinger, and pull
the sleeve out to release the X2 transceiver from the socket connector. (See
Figure 6-19
Removing the 10-Gigabit Ethernet X2 Transceiver
Step 3
Slide the 10-Gigabit Ethernet X2 transceiver out of the socket and immediately place it in an antistatic
bag.
Step 4
Re-install the socket cover if you are not installing an X2 transceiver in the empty socket.
a.
Position the socket cover in front of the socket opening.
b.
Snap the socket cover in place.
X2 Transceiver Maintenance Guidelines
To properly maintain X2 transceivers, follow these guidelines:
•
To prevent ESD damage, follow normal handling procedures.
120756
LINK
ACTIVE
1
LINK
ACTIVE
2
