Figure 30: Unlocking a Fabric Module from its Slot
Pull the handles to partially remove the module from
the slot.
3
Press the eject button.
1
Handles spring out from the module.
2
b) Grasp each of the two levers with your two hands and fully rotate the levers out 90 degrees from the fabric module.
c) Pull both levers until the fabric module is about 3 inches (7 cm) out of the chassis (see Callout 3 in the previous
figure).
d) Rotate both levers back to the front of the module.
Each lever clicks when it locks in place at the front of the module.
e) Grasp the front of the module with one hand, place the other hand under the module to support its weight, and pull
the module out of the slot (see Callout 2 in the previous figure).
Be careful not to touch any electrical contacts on the back of the module. Handle only covered sides or
edges of the module.
Caution
f)
Place the module on an antistatic surface or inside an antistatic bag.
Step 3
Install the new fabric module in the chassis as follows:
a) Unpack the new fabric module and inspect it for damage.
If anything is damaged or missing, contact your customer representative immediately.
b) Hold the front of the module with one hand and place the other hand under the module.
c) Rotate the module clockwise and align the back of the module to the module guides at the top and bottom of the open
fabric slot in the chassis.
d) Push the module half way into the slot (see the following figure).
Cisco Nexus 7706 Hardware Installation Guide
OL-31330-01
100
Installing or Replacing Modules, Fan Trays, and Power Supplies
Installing or Replacing a Fabric Module
