8-7
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
OL-24002-01
Chapter 8 Installing and Removing the ASA 5500 AIP SSM
Installation and Removal Instructions
•
For the procedure for using HTTPS to log in to the IDM, refer to
Logging In to the IDM
.
Verifying the Status of the ASA 5500 AIP SSM
You can use the
show module 1
command to verify that the ASA 5500 AIP SSM is up and running.
The following values are valid for the Status field:
•
Initializing
—The ASA 5500 AIP SSM is being detected and the control communication is being
initialized by the system.
•
Up
—The ASA 5500 AIP SSM has completed initialization by the system.
•
Unresponsive
—The system encountered an error communicating with the ASA 5500 AIP SSM.
•
Reloading
—The ASA 5500 AIP SSM is reloading.
•
Shutting Down
—The ASA 5500 AIP SSM is shutting down.
•
Down
—The ASA 5500 AIP SSM is shut down.
•
Recover
—The ASA 5500 AIP SSM is attempting to download a recovery image.
To verify the status of the ASA 5500 AIP SSM, follow these steps:
Step 1
Log in to the adaptive security appliance.
Step 2
Verify the status of ASA 5500 AIP SSM. If the status reads
Up
, the ASA 5500 AIP SSM has been
properly installed.
asa#
show module 1
Mod Card Type Model Serial No.
--- -------------------------------------------- ------------------ -----------
1 ASA 5500 Series Security Services Module-20 ASA-SSM-20 P2B000005D0
Mod MAC Address Range Hw Version Fw Version Sw Version
--- --------------------------------- ------------ ------------ ---------------
1 000b.fcf8.0144 to 000b.fcf8.0144 0.2 1.0(9)0 5.0(0.27)S129.0
Mod Status
--- ------------------
1 Up
asa#
Removing the ASA 5500 AIP SSM
To remove the ASA 5500 AIP SSM from the adaptive security appliance, follow these steps:
Step 1
Shut down the ASA 5500 AIP SSM.
asa#
hw-module module 1 shutdown
Shutdown module in slot 1? [confirm]
Step 2
Press
Enter
to confirm.
Step 3
Verify that the ASA 5500 AIP SSM is shut down by checking the indicators.
Step 4
Power off the adaptive security appliance.