14
Wall-Mounting the Cisco IAD2430, Cisco IAD2431, and Cisco IAD2432 IADs
To wall-mount a Cisco IAD2430, Cisco IAD2431, or Cisco IAD2432 IAD, follow these steps:
Step 1
Attach the short side of one bracket to the chassis, as shown in Figure 12, using two 6-32 x 1/4 slotted hex screws
(provided). Be sure to use a plastic washer (provided) with each screw; the narrow end of the washer must fit into the
bracket slot, facing the chassis.
Caution
Be sure to use the correct screws and plastic washers for this mounting option. (See Table 1 on page 11.)
Figure 12
Attaching the Brackets for Wall-Mounting
Step 2
Attach the second bracket to the other side of the chassis.
Step 3
Attach the router to the wall by using the brackets and attachment hardware that you provide, as follows:
•
You can install a starter screw in the wall, and hook the bracket keyhole over the screw. This holds the unit in place
for easy installation of the attachment screws.
•
Attach both brackets to the wall.
Note
For attaching to a wall stud, each bracket requires two number-10 wood screws (round- or pan-head) with
number-10 washers, or two number-10 washer-head screws. The screws must be long enough to penetrate at
least 3/4 inch (20 mm) into the supporting wood or metal wall stud.
Note
For hollow-wall mounting, each bracket requires two wall anchors with washers. Wall anchors and washers
must be size number 10.
Figure 13 shows the orientation required for installing the Cisco IAD2430, Cisco IAD2431, or Cisco IAD2432 IADs.
88843
