13
Figure 11
Cisco IAD2435 IAD Rack-Mounting with Back Panel Forward
Step 2
Install the chassis in the rack, using screws that you purchase.
Setting the Chassis on a Desktop
You can set the Cisco IAD2430 series IADs on a desktop. To place the Cisco IAD2430, Cisco IAD2431, or Cisco IAD2432 IAD
on a desktop follow these steps:
Step 1
Verify that a suitable AC power outlet is available.
Caution
Do not plug this unit into an AC outlet that does not have a UL-certified receptacle that is properly tied into the
building ground.
Step 2
Place the four rubber feet (from the accessory kit) in the four indentations on the underside of the chassis. The slight
elevation provided by the rubber feet helps provide proper airflow through and around the chassis.
Step 3
Place the Cisco IAD on a smooth, flat surface.
Caution
Do not place anything on top of the chassis that weighs more than 10 lb (4.5 kg). Excessive weight on top can
damage the chassis.
Setting the Cisco IAD2435 on a Desktop
You can also place the Cisco IAD2435 IAD on a desktop. To place the Cisco IAD2435 IAD on a desktop follow the preceding
steps.
Caution
Do not place anything on top of the router that weighs more than 5 pounds (2.25 kg), and do not stack routers on
a desktop. Excessive distributed weight of more than 5 pounds, or pound point load of 5 pounds on top could
damage the chassis.
After you install the router, you must connect the chassis to a reliable earth ground. For the chassis ground connection
procedures, see the “Grounding the Chassis” section on page 18.
Wall-Mounting the Chassis
Caution
You can wall-mount the Cisco IAD2430, Cisco IAD2431, or Cisco IAD2432 IAD with either the right side or the
left side facing up; however, the front and back panels must be vertical. The Cisco IAD2435 IAD must be mounted
with the front panel facing up.
231983
IAD2435-8FXS
12V DC
SA
CONSOLE
AUX
FastEthernet
WAN
0/1
0/0
T1/E1
FXS