CAUTION
Overwriting the firmware of any electronic device must be done
with great care, and always contains an element of risk.
It is not advisable to overwrite the firmware on a functioning
Fluidmesh unit unless a specific firmware-related issue needs
to be resolved.
IMPORTANT
To access firmware image files, you need an approved
Fluidmesh extranet account. To create an extranet account,
register for free at the
.
To download the needed firmware image file to your computer, do the
following steps:
1.
the Documentation section of the Fluidmesh Partner
.
2.
Find and open the device sub-folder for your specific Fluidmesh
device in the
FIRMWARE AND TOOLS
folder.
3.
Download the firmware image (*.BIN) file to your computer.
CAUTION
Make sure that you download the specific *.BIN file
for your device type. Uploading incorrect firmware for
the device type will cause the firmware overwrite to
fail, and may damage the unit.
The following procedure describes how to overwrite the existing firmware
on a Fluidmesh device. This procedure assumes that the wireless network
is currently active.
To overwrite the existing firmware on the Fluidmesh device, do the
following steps:
1.
Power OFF all Fluidmesh devices connected to the wireless
network.
2.
Disconnect all Ethernet cables from the Fluidmesh device.
3.
With the Fluidmesh device disconnected from the wireless
network, power ON the device.
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 96 of 138
