Using SNMP v2c
To change the unit's SNMP mode to
v2c
and configure the unit
accordingly, do the following steps:
1.
Click the
SNMP mode
drop-down, and click the
v2c
option.
• The
SNMP
v2c settings dialog will be shown (
).
Figure 35. SNMP dialog (v2c selected)
2.
Enter a community identity value in the
Community ID:
field.
IMPORTANT
The same community identity value must be set for
all Fluidmesh units in the wireless network.
3.
SNMP traps can be enabled for significant system-related events.
If needed, enable SNMP event traps by checking the
Enable
SNMP event trap:
check-box, and enter the name of the network
management station (NMS) host in the
NMS hostname:
field.
IMPORTANT
The NMS host to which traps are sent must have an
SNMP agent that is configured to collect SNMP v2c
traps.
4.
You can also configure the unit to send SNMP traps at defined
periodic intervals. If needed, enable periodic SNMP traps by
checking the
Enable SNMP periodic trap:
check-box, and enter
the name of the network management station (NMS) host in the
NMS hostname:
field.
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 78 of 138
