The tracefiles in the crashinfo directory are located in the following formats:
1.
Process-name_Process-ID_running-counter.timestamp.gz
Example: IOSRP_R0-0.bin_0.14239.20151101234827.gz
2.
Process-name_pmanlog_Process-ID_running-counter.timestamp.bin.gz
Example: wcm_pmanlog_R0-0.30360_0.20151028233007.bin.gz
Configuring Conditional Debugging
To configure conditional debugging, follow the steps given below:
SUMMARY STEPS
1.
enable
2.
debug platform condition mac
{
mac-address
}
3.
debug platform condition start
4.
show platform condition
OR
show debug
5.
debug platform condition stop
6.
request platform software trace archive
[
last
{
number
}
days
] [
target
{
crashinfo:
|
flashinfo:
}]
7.
show platform software trace
[
filter-binary
|
level
|
message
]
8.
clear platform condition all
DETAILED STEPS
Purpose
Command or Action
Enables privileged EXEC mode. Enter your password if
prompted.
enable
Example:
Step 1
Device>
enable
Configures conditional debugging for the MAC Address
specified.
debug platform condition mac
{
mac-address
}
Example:
Step 2
Device#
debug platform condition mac bc16.6509.3314
Starts conditional debugging (this will start radioactive
tracing if there is a match on one of the conditions above).
debug platform condition start
Example:
Step 3
Device#
debug platform condition start
Displays the current conditions set.
show platform condition
OR
show debug
Example:
Step 4
Device#
show platform condition
Device#
show debug
Stops conditional debugging (this will stop radioactive
tracing).
debug platform condition stop
Example:
Step 5
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
233
Conditional Debug and Radioactive Tracing
Configuring Conditional Debugging
