C H A P T E R
15-1
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
15
Configuring Access Control
This chapter describes how to configure the access control lists (ACLs) on the Catalyst 6500 series
switches. The configuration of the ACLs depends on the type of hardware that you install on your
supervisor engine. See the
“Hardware Requirements” section on page 15-2
for more information.
Note
For complete syntax and usage information for the commands that are used in this chapter, refer to the
Catalyst 6500 Series Switch Command Reference
publication.
Note
For detailed information on configuring policy-based ACLs (PBACLs), see the
“Configuring
Policy-Based ACLs” section on page 44-21
.
This chapter consists of these sections:
•
Understanding How ACLs Work, page 15-2
•
Hardware Requirements, page 15-2
•
Supported ACLs, page 15-3
•
Applying Cisco IOS ACLs and VACLs on VLANs, page 15-7
•
Using Cisco IOS ACLs in your Network, page 15-9
•
Using VACLs with Cisco IOS ACLs, page 15-17
•
Using VACLs in Your Network, page 15-25
•
Unsupported Features, page 15-44
•
Configuring VACLs, page 15-44
•
Configuring MAC-Based ACL Lookups for All Packet Types, page 15-61
•
Configuring and Storing VACLs and QoS ACLs in Flash Memory, page 15-64
•
Configuring Port-Based ACLs, page 15-68
•
Configuring ACL Statistics, page 15-81
•
Configuring Policy-Based Forwarding, page 15-90
•
Downloadable ACLs, page 15-116
