© 2017 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Page 13 of 146
Cisco C880 M4 Server Configuration
This section describes how to configure the Cisco C880 M4 Server.
Set Up the Cisco Integrated Management Controller
First you need to configure the onboard Cisco Integrated Management Controller (IMC).
1. Connect an RS-232 cable to the communications (COM) port.
2. Connect the user ports (IMC ports) to the customer management network and VLAN to access the IMC
over your web browser (Figure 8). These two ports function as clustered ports.
Figure 8.
Cisco C880 M4 MMB Connections
MMB Connectors View
RS-232 Cable
RJ-45 Connection
Customer
Management Network
CIMC Ports
100 MB/S
Note:
After you power on the controller, wait for the ready (RDY) and active (ACT) LEDs to display a steady
green light before performing the initial setup.
Connect to the Management Board
After you turn on the power, the MMB initialization process starts. During the initialization process, the MMB RDY
LED flashes and the alarm LED of the unit in the front turns on.
After the initialization process is complete, the MMB RDY LED stops flashing and changes to a steady green light.
1.
Verify that the COM port of the MMB is connected to the technician’s system.
2. Set up the IP address for the IMC. Open a new serial connection using putty with the settings shown in
Table 1.
