Installing the Interface Module
Before installing the interface module, read the Activating or Deactivating Interface Module section in the
Cisco ASR 920 Series Aggregation Services Router Configuration Guide
Note
Procedure
Step 1
Before inserting an interface module, make sure that the chassis is grounded.
Step 2
If present, remove the blank filler plate covering the interface module slot. To remove, pull the blank filler
plate completely out of the router slot using the captive screws.
Step 3
To insert the interface module, carefully align the edges of the interface module between the upper and lower
edges of the interface module slot in the router.
Step 4
Carefully slide the interface module into the router slot until the interface module makes contact with the
backplane. The following figure shows how to install the interface module on Cisco ASR-920-24SZ-IM
Router.
Figure 14: Inserting an Interface Module on Cisco ASR-920-24SZ-IM Router
Installing the Router
15
Installing the Router
Installing the Interface Module
