C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
Software Package Management Commands on Cisco IOS XR Software
show install audit
SMR-386
Cisco ASR 14000 Series Router System Management Command Reference
OL-17231-01
Note the following about the audit file:
•
Each package or SMU name must be on a separate line.
•
Comments are allowed and must begin with the pound character: #
•
SMUs can be specified with a package name only; regular packages should be specified as
“package-version”. For SMUs, if a version is not specified, the default version of “1.0.0" is used.
•
Composite package names are allowed
•
PIE extensions are allowed at the end of the package name, and they are stripped off.
•
The maximum number of lines in a file is limited to 100; the maximum length of each line is limited
to 256 characters.
Following are the contents of a valid audit file:
# R3.4.1
# some comments
#
comp-asr14k-mini-3.7.1
asr14k-mgbl-3.7.1
asr14k-mcast-3.7.1
asr14k-mpls-3.7.1
asr14k-base-3.7.1.CSCek42760
asr14k-base-3.7.1.CSCse14607
asr14k-mpls-3.7.1.CSCse00294
comp-asr14k-3.7.1.CSCsd07147
Displaying Information for a Specific SDR
•
To display information for a specific SDR from administration EXEC mode, use the
sdr
keyword
and
sdr-name
argument.
•
To display information for an SDR when logged into that SDR, enter the command in
EXEC mode.
Displaying Information for a Specific Node
Use the
location
keyword and
node-id
argument to display information for a specific node. If you do not
specify a location with the
location
keyword and
node-id
argument, this command displays information
for all nodes.
Verbose Information
Use the
verbose
keyword to display additional information, including component and file information
for each package.
Command Output
Output from the
show install audit
command provides the following information regarding the audit:
1.
The command finishes successfully, and the result of the audit is success. This means that all
packages listed in the audit file are active, and there are no extra packages active on all nodes where
the audit was requested. This can refer to the entire router, a particular SDR, or a particular node.
2.
The command completes successfully, and the result of the audit is failure. Audit failure means that
there are discrepancies between the set of packages listed in the audit file and the packages active
on the nodes where audit is done.
The following additional messages indicate the type discrepancy found in the audit:
–
A package specified in the audit file is not present at all. In other words, there was no
install
add
performed for this package.
