3-14
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-26223-04
Chapter 3 Router Hardware Description
Hardware Features Detailed Description
Figure 3-10
Cable Port Seal
Console Port
The router features a single, asynchronous console port (see
Figure 3-4
and
Figure 3-11
) for connecting
a console or PC directly to the router. To configure the router locally, using the command-line interface
(CLI), you must establish a connection to the router with a terminal session.
Caution
This port does not support cable glands; the router interior is exposed to environmental elements while
the port is in use. This port should be exposed only during active terminal sessions with the router and
should never be left unattended when exposed.
Note
The router also supports wireless console connections with an integrated WiFi short-range access point.
For more information see, the
“WiFi Short-Range Access Point” section on page 3-34
.
Console Port Default Settings
The console port does not support hardware flow control. The default settings for the port are:
9600 baud, 8 data bits, no parity, and 1 stop bit.
Connecting to the Console Port
Your router kit includes a console cable with an RJ-45 connector on one end (for connecting to the router
console port) and a DB-9 connector on the other end (for connecting to a PC or terminal).
Detailed information about connecting and using the console port is in the
“Installing the Router”
chapter.
300542
