Figure 85: Removing a Fabric Card from the Chassis
Two captive screws (one on each handle)
3
Pull on both handles to partially remove the
fabric card from the chassis
1
Rotate both ejector handles to the front of the
module
2
d) Place one hand under the fabric card to support its weight, place your other hand on the front of the module,
and slide the module out of the slot.
e) Rotate both handles back to the front of the module until they are in place. Fasten each handle to the
module using the captive screw on the back of the handle. Tighten the screw to 8 in-lb (0.9 N·m) of torque.
f)
Rotate the module 90 degrees and lay it flat on an antistatic surface or in an antistatic bag.
Hardware Installation Guide for Cisco 8800 Series Routers
121
Replace Chassis Components
Remove a Fabric Card
