Step 11
Tighten the cable management brackets screws to 11.5 to 15 in-lb (1.3 to 1.7Nm) of torque after completing
the bottom cover, and top hood installation.
Attach Front Door to Chassis
Before you begin
Before you can attach the front door to the chassis, you must attach the cable management brackets, bottom
plate, and top hood onto the chassis.
Required tools and equipment:
• Phillips screwdriver with a torque capability (customer supplied)
• Door kit (8818-KIT, 8812-KIT, 8808-KIT, or 8804-KIT)
The door kit is optional.
Note
Procedure
Step 1
Remove the power shelf bezel from the chassis, if already installed.
This is to ease the installation of chassis doors.
Step 2
On the back side (open side) of one door, pull in on two protruding spring pins so that the pins are held inside
the door frame.
Hardware Installation Guide for Cisco 8800 Series Routers
56
Unpack and Install the Chassis
Attach Front Door to Chassis
