3-21
Catalyst 6500 Series Ethernet Modules Installation Guide
OL-6265-03
Chapter 3 Installing Ethernet Switching Modules
Installing Pluggable Transceivers
Step 4
Insert the X2 transceiver into the transceiver socket on the system module front panel. (See
Figure 3-16
,
top view.) Continue sliding the X2 transceiver into the socket until the X2 transceiver EMI gasket is flush
against the system module faceplate. The X2 transceiver connector is now mated to the socket connector.
Step 5
Verify that the X2 transceiver latches are fully engaged. Secure the X2 transceiver by sliding the
transceiver latching sleeve toward the system module faceplate. (See
Figure 3-16
, bottom view.)
Caution
If the latches are not fully engaged, you might accidently disconnect the X2 transceiver.
Figure 3-16
Installing the 10-Gigabit Ethernet X2 Transceiver
1
LINK
LINK
AC
TIVE
2
AC
TIVE
130045
1
LINK
LINK
AC
TIVE
2
AC
TIVE
