2-4
Cisco Video Surveillance 6500PD IP Camera Installation Guide
Chapter 2 Camera Installation
Installing the IP Camera
Installing the IP Camera
To install the Cisco Video Surveillance 6500PD IP Camera, perform the following steps:
Procedure
Step 1
Turn the lens clockwise into the lens opening until it stops (see
Figure 2-1
). If necessary, turn it
counterclockwise slowly until it gets the best attitude. The IP camera accepts CS-mount lenses with a
lens protrusion of up to 5 mm.
Figure 2-1
Mounting the IP Camera Lens
Ensure that the lens is clean because any dirt may degrade the quality of video images.
Note
Save the lens opening dust cap and replace the dust cap if you remove the lens.
Step 2
Connect the P-iris lens cable to the P-iris lens connector on the back of the IP camera (see
Figure 2-2
).
Figure 2-2
Mounting the IP Camera Lens
Step 3
Optional.
Use the GPIO terminal block ports on the back of the IP camera to connect an external device
that triggers alarms (connect through input port) or responds to alarms (connect through output port).
Figure 2-3
shows the GPIO terminal block pin locations and descriptions.
