Cisco 124778, User Manual

Page: 66 / 96

3-8
Cisco AC/DC Power System User Guide, R1.0
May 2006
Chapter 3 Component Replacement
3.2.4 Replace a Rectifier
Figure 3-8 Removing a Circuit Breaker
Step 5
Remove the alarm cable connections from the rear of the breaker ( Figure 3-8 ).
Step 6 Pull the breaker straight out from the 1RU Distribution Shelf.
Step 7
To reinstall a replacement 1RU Distribution Shelf see the “2.2.2 Install the 1 RU Distribution Shelf”
procedure on page 2-6 .
3.2.4 Replace a Rectifier
Note
For more information on uninstalling a rectifier, see the “4.2.2.3 Remove Modules” section on
page 4-3 .
Step 1
Locate the rectifier that is to be removed.
Step 2
Loosen the mounting screws to allow the rectifier handle to open ( Figure 3-9 #1).
Step 3
Grasp the top of the handle and pull down until the handle locks into the open position ( Figure 3-9 #2).
124757