Cirrus SR20, Maintenance Manual

Page: 63 / 70

C I R R U S
C O M P O N E N T M A I N T E N A N C E M A N U A L - C A P S M O D E L S R 2 0
95-01-01
Page 63
All
EFFECTIVITY:
E. Activation Handle and Cable Assembly (See Figure 95-01-0114) , (See Figure 95-01-0115)
(1) Removal - Activation Handle and Cable Assembly
(a)
Acquire necessary tools, equipment, and supplies.
(b) Remove handle access cover and install safety pin.
CAUTION: Ensure hands are clean while working with headliners and trim pieces.
(c) Remove BH 222 trim panel and carpet. (Refer to AMM 25-10)
(d) Serials 1005 thru 1267 after SB2X-95-20: Disconnect battery 1 from both positive and
negative terminals. (Refer to AMM 24-30)
(e) Remove access panels CB6 and CB7 from BH 222. (Refer to AMM 06-00)
(f) To prevent debris and components from falling into bottom of empennage, place catch
cloth below rocket and parachute assembly.
(g) Remove LH rear headliner. (Refer to AMM 25-10)
(h) If applicable, remove fasteners securing cabin headliner to fuselage.
(i) Remove LH and RH cabin flood light assemblies. (Refer to AMM 33-10)
(j) Pull LH door seal away from top edge of door frames. (Refer to AMM 53-40)
(k) If applicable, slit tape securing LH headliner to door frame.
(l) Remove LH B-pillar trim. (Refer to AMM 25-10)
(m) Gently pull LH portion of cabin headliner down from ceiling to gain access to activation
cable.
(n) Remove rocket assembly. (Refer to 95-01-01)
(o) Remove grommet securing activation cable to cable pass-through hole in parachute com-
partment.
Note: To facilitate screw removal, push attaching screws up to break filler covering
screw heads and use a small knife to remove remaining filler.
(p) At activation handle, remove nuts, washers, bushings, and screws securing activation
handle and cable assembly to fuselage.
(q) Locate, cut, and remove all cable ties securing activation cable to the fuselage ceiling.
(r) Remove aluminum tape securing activation cable to fuselage ceiling.
(s) Remove activation cable from airplane.
(2) Installation - Activation Handle and Cable Assembly
(a)
Acquire necessary tools, equipment, and supplies.
Description P/N or Spec. Supplier Purpose
Telescoping Magnet - Any Source Retrieval.
Small Knife - Any Source Facilitate removal of
attach screws.
Description P/N or Spec. Supplier Purpose
Activation Handle and
Cable Assembly Reference
Parts List Cirrus Design CAPS
Activation.
4 May 2015