95-01-01
Page 46
Serials 1005 thru 1267 before SB2X-95-20, 1268 thru
1422 before SB2X-95-17
EFFECTIVITY:
C I R R U S
C O M P O N E N T M A I N T E N A N C E M A N U A L - C A P S
M O D E L S R 2 0
4 May 2015
Figure 95-01-0111
Rocket Installation - Serials 1005 thru 1267 before SB2X-95-20, 1268 thru 1422 before SB2X-95-17 (2 of 10)
SR20_CM95_1537E
ROCKET IGNITER
(REF)
FIRING PIN ACTUATOR
(REF)
ANCHOR BLOCK
(REF)
RETAINING GROOVE
(REF)
RETAINING GROOVE
(REF)
LEGEND
2. Washer
6. Rocket Lanyard
7. Grommet
9. Pick-up Collar
10. Pick-up Collar Support
11. Screw
12. Rocket Cone
13. Activation Cable
14. Plug
15. Launch Tube
16. Rocket Motor
17. Shelf
18. Shield
19. Cone Adapter
11
11
2
12
13
14
9
10
11
11
6
15
16
2
11
Verify anchor blocks are perpendicular to pick-up
collar assembly. If pick-up collar assembly is not
fully seated against the anchor blocks, use pliers
to gently adjust anchor blocks as required.
Position inspection hole on rocket cone so that hole faces
forward once installed.
Position retaining groove of pick-up collar support to rocket lanyard.
Pivot pick-up collar support until the rocket lanyard engages the opposite
retaining groove.
NOTE
Do not overtighten aluminum tension screws.
Torque to 1 - 5 in-lb (12 - 56 Ncm).
Position rocket lanyard around top outer diameter
of pick-up collar support, NOT over top of the rocket.
Failure to comply will absolutely FAIL rocket
deployment!
18
17
19
7
6
Serials 1005 thru 1267 before SB2X-95-20, 1268 thru 1422 before SB2X-95-17.
Apply light threadlocker to screws.
Apply medium threadlocker to screws.
Upon disassembly, safety the rocket motor by wiring firing pin actuator to
rocket igniter.
