Circo G20 Installation Manual Download Page 14

Page: 14 / 36

English

I NS TAL L ATI O N MA N U A L

5.11.2 Restrictor slide

The restrictor slide (R) is supplied separately (see Appendix 3, Fig. 14).
It is mounted as follows:

Remove the glass pane as described in section 5.10.1;

Fully unscrew the 2 bolts of the top panel (see Appendix 3, Fig. 8 (P));

Remove the top panel (G);

Unscrew the 2 self-tapping screws of the upper cover plate (see Appendix 3, Fig. 14 (J));

Remove the upper cover plate (J);

Unscrew the 2 self-tapping screws from the combustion chamber; they are on the inside at the top of the
appliance;

Place the restrictor slide (R);

!Caution

The restrictor slide may only be placed in one way. Therefore, observe the instructions in Appendix 3, Fig. 14.

Tighten the 2 self-tapping screws by a few strokes, but not yet fully tight;

Set the position of the restrictor in accordance with table 6;
In the restrictor slide, the 3 possible positions are indicated by 3 cut out triangles. The letters at these triangles
correspond with the letters in table 6.

Make sure that the point of the triangle that belongs to the position required by you and the centre of the
self-tapping screw are exactly aligned.

Now tighten the 2 self-tapping screws;

Place back the upper cover plate;

Place back the top panel;

Place back the glass pane as described in section 5.10.2.

5.12 Wood set

The appliance is supplied with a wood set.

!Caution

Strictly observe the following instructions to prevent unsafe situations:

only ever use the supplied wood set

place the wood set exactly as described

make sure the pilot burner and the surrounding space remain free (see Appendix 3, fig. 15);

make sure thermocouple 2 and the surrounding space remain free (see Appendix 3, fig. 16);

make sure the slot between and around the burners remains free;

make sure that the vermiculite’s fine dust does not get on the burners.

5.12.1 Wood set

The wood set consists of vermiculite (see Appendix 3, fig. 17), chips (see Appendix 3, fig. 18) and a number of logs.
Glow material (see appendix 3, fig. 19) is not part of the appliance's standard equipment and is available at your
dealer.

Fill the burners with vermiculite; spread the vermiculite evenly (see Appendix 3, fig. 20). The vermiculite may not
reach higher than the edge of the burners.

!Caution

You can influence the flame picture by moving the vermiculite,

yet the burner decks have to remain covered with vermiculite in order to prevent that the life span of the
burners is reduced.

Identify the logs A to D (see Appendix 3, fig. 21).

!Tip

Use the burn stains on the logs for identification.

Place log A and part of the supplied chips at the back of the combustion chamber (see Appendix 3, fig. 22).

Place log B over the burner and on log A (see Appendix 3, fig. 23).

Place log C in the position bracket and on log B. Spread out the remaining chips (see Appendix 3, fig. 24).

!Caution

Do NOT place chips over the slot around and between the burners.

Then place log D in front of the burner on log C and the chips (see Appendix 3, fig. 25).