- 16 -
Automatic Temperature Control Setting
NOTE: On diesel units, the engine must be running before activating temperature
control. The automatic temperature control system monitors the heat transfer
oil temperature and material temperature (Refer to diagram 11).
1)
Set the oil controller (A) to 550º F (See Setting Temperature Controllers, pg. 17)
2)
Set the material controller (B) to the recommended material working temperature which
is typically listed on the material container.
3)
On units with heated hose, set the hose controller (C) to the pour temperature.
4)
Turn rocker switch (D) on. The switch will light up to indicate that the control system is
activated. The oil control indicator (F) will light also. The material control light (G) will
be on only when burner is running. Lights (D,F and G) should light during a cold start
up.
5)
Turn switch (H) on to activate the heated hose (if equipped). The switch will light up to
indicate power is on.
6)
Hose indicator light (J) will light only when hose is being heated.
7)
Switch (E) is used to activate remote control sealing wand valve (if equipped).
8)
Switch (I) is used to activate any optional accessories.
A
B
C
F
D
H
I
G
J
E
Diagram 11
Summary of Contents for MAGMA 110
