- 13
-
Bottle Hookup and Ignition (LP Units only)
NOTE: Liquid withdrawal requires optional hose adapters and engine vaporizer
(Diagram 4).
1)
Place 100 lb. propane bottle(s) in rack and secure in place with chain binder(s).
2)
Connect hoses (A) to bottle(s).
NOTE: POL fittings are left hand thread. All connections must be air tight.
3)
Close hand torch supply valve (B). (optional)
4)
On models with optional two bottles, open the valve (C) from one bottle or the other.
5)
Open valve on LP bottle and set regulator (D) at 13 to 14 PSI.
WARNING: DO NOT exceed 14 PSI.
6)
Set the oil controller (E) to 550º F (Diagram 5).
DO NOT
exceed 550º F. Set the
material controller (F) to the recommended material working temperature (typically
listed on can or box). (optional)
7)
Turn the rocker switch (G) on. The light in the switch will indicate that the control system
is on.
NOTE: If the burner does not ignite within 8-10 seconds, the unit will require reset-
ting. Turn switch "off", allow time for the unburned fuel to exit the chamber
and repeat procedure.
8)
If ignition does not occur, check the fuse and gas supply.
B
A
C
D
C
A
E
F
G
Diagram 4
Diagram 5
Summary of Contents for MAGMA 110
