38
D
4.1.4 Abtauen
Der Monoblock führt in zyklischen, vom Hersteller voreingestellten Zeiträumen den Abtauvorgang durch.
Falls unter bestimmten Betriebsbedingungen (sehr heiße oder schwüle Jahreszeiten, häufiges Öffnen der Türen...) der
Abtauvorgang den Verdampfer nicht vollständig vom Eis befreit, kann ein zusätzlicher Abtauvorgang manuell durch-
geführt werden.
Die Taste DEFROST/UP (1) länger als 5 Sekunden BETÄTIGEN, um den manuellen Abtauvorgang einzuleiten, der nur
unter den entsprechenden Bedingungen aktiviert wird..
4.1.5 Ausschalten
Um den Monoblock auszuschalten, die TASTE ON/OFF (0) drücken.
Wird das Gerät für einen längeren Zeitraum abgeschaltet, sollte die Verbindung zum Stromnetz unterbrochen werden.
4.2 ALARM- UND WARNHINWEISE
AUF DEM SCHALTFELD (4) WERDEN AUF DEM DISPLAY DIE FEHLERHINWEISE (ALARM) ANGEZEIGT, WENN DIE FÜHLER
BETRIEBSSTÖRUNGEN ERFASSEN. ES FOLGT EINE LISTE MÖGLICHER FEHLERMELDUNGEN:
“ E1 “ FEHLER ZELLENSONDE
ZELLENSONDE MIT SENSOR DEFEKT.
ZELLENSONDE UNTERBROCHEN.
ZELLENSONDE NICHT ANGESCHLOSSEN.
ZELLENSONDE MIT INSTRUMENT INKOMPATIBEL.
ÜBERSCHREITUNG DER UNTEREN ANZEIGEGRENZE ( -55 ).
ÜBERSCHREITUNG DER UNTEREN ANZEIGEGRENZE ( +99 ).
“ E2 “ FEHLER ABTAUFÜHLER
ABTAUFÜHLER MIT SENSOR DEFEKT.
ABTAUFÜHLER UNTERBROCHEN.
ABTAUFÜHLER NICHT ANGESCHLOSSEN.
ABTAUFÜHLER MIT INSTRUMENT INKOMPATIBEL.
ÜBERSCHREITUNG DER UNTEREN ANZEIGEGRENZE ( -55 ).
ÜBERSCHREITUNG DER UNTEREN ANZEIGEGRENZE ( +99 ).
5. NORMALE UND REGELMÄSSIGE WARTUNG
Die Anleitungen zur normalen Wartung in diesem Kapitel sind an
nicht geschultes, aber instruiertes Personal
gerichtet.
Die regelmäßige/programmierte Wartung ist dem Fachpersonal vorbehalten.
5.1 GRUNDREGELN ZUR SICHERHEIT
Dieser Abschnitt informiert den Anwender des Monoblocks über die vor normalen Wartungsarbeiten auszuführenden
Grundregeln zur absoluten Sicherheit.
5.1.1 Wichtigste Maßnahmen
Vor
jeglichen Wartungsarbeiten ist das Gerät von dem Stromnetz zu trennen:
- Den Hauptschalter betätigen, das DISPLAY schaltet ab
- Den Stecker ziehen
Handschuhe verwenden,
um Wartungen in der Nähe von „Hohen und Niedrigen Temperaturen“ durchzuführen