39
D
5.1.2 Warnhinweise
Nicht mit feuchten Händen oder barfuß in die Nähe der elektrischen Teile kommen.
Kein Werkzeug oder andere Gegenstände durch das Schutzgitter der Ventilatoren einführen.
Wahrend der Wartungsarbeiten keine Schutzvorrichtungen entfernen (Gitter, Aufkleber, usw.).
5.1.3 Notmaßnahmen bei Feuer
Bei Feuer KEIN Wasser verwenden. Einen
Feuerlöscher
einsetzen und so schnell wie möglich den Bereich des
Brandherds abkühlen.
5.2 GERÄTEREINIGUNG
5.2.1 Reinigung der Oberflächen
Zur Reinigung der inneren und externen Oberflächen des
Monoblocks ein feuchtes Tuch verwenden.
KEINE chemischen Reinigungs- und/oder Scheuermittel,
sondern nur neutrales Spülmittel und lauwarmes Wasser
verwenden.
KEINE Mittel verwenden, die Kratzer und anschließende
Rostbildung verursachen.
Mit sauberem Wasser spülen und gründlich trocknen.
5.2.2 Reinigung des Kondensators
Diese Reinigung muss durch
Fachpersonal
ausgeführt
werden.
Um die Leistungsfähigkeit des Geräts konstant zu halten
muss regelmäßig der Kondensator gereinigt werden, um
zu verhindern, dass Verkrustungen und
Schmutzablagerungen den Luft- oder Wasserfluss (bei
Kondensatoren mit Wasser) beeinträchtigen. Dieser
Vorgang erfolgt unter normalen Bedingungen übli-
cherweise alle
zwei Monate
, kann aber selbstverständli-
ch je nach Betriebsumgebung des Geräts häufiger durch-
geführt werden.
Zur Reinigung werden benötigt: ein InbusschlUussel, ein
langhaariger Pinsel oder besser, Druckluft.
Fig.5.2.2.a
Fig.5.2.2.b
REINIGUNG DES KONDENSATORS MIT EINEM PINSEL
A)
Das Gerät
ABSCHALTEN
und vom Stromnetz tren-
nen.
B)
Den Kondensator reinigen, wobei der Pinsel sorgfältig
von vorne zur Zellenwand geführt
werden
muss (Abb.
5.2.2.a).
REINIGUNG DES KONDENSATORS MIT DRUCKLUFT.
A)
Das Gerät
ABSCHALTEN
und vom Stromnetz tren-
nen.
B)
Das Frontpaneel durch Lösen der Schrauben am
Gehäuse
ABNEHMEN
(Abb. 5.2.2.b)
C)
Den Kondensator reinigen, wobei der Druckluftstrahl von innen nach
außen
zu führen ist (Abb. 5.2.2.c).