Chroma 69200-1, User Manual

Page: 37 / 86

Installation
3-13
Command Description
SOURce:POWer? Query power setting value.
SOURce:VOLTage:CUTOFF Set the cutoff voltage parameters. Unit (V). There are three
decimal points. Range based on machine specifications.
SOURce:VOLTage:CUTOFF? Query cutoff voltage setting value.
SOURce:CURRent:CUTOFF Set the cutoff current parameters. Unit (A). There are three
decimal points. Range based on machine specifications.
SOURce:CURRent:CUTOFF? Query cutoff current setting value.
SOURce:CURRent:SLEW
Set the current slew rate parameters. Unit (A/ms). There are
three decimal points. Range based on machine
specifications.
SOURce:CURRent:SLEW? Query current slew rate setting value.
SOURce:MODe Set output mode.
SOURce:MODe? Query output mode.
MEASure:ALL? Query all measurement values.
MEASure:OPER? Query operation status.
MEASure:TIME? Query measurement time.
MEASure:STATe? Query protection status.
MEASure:TEMP? Query measurement temperature.
MEASure:VOLT? Query measurement voltage.
MEASure:CURR? Query measurement current.
MEASure:POW? Query measurement power.
MEASure:AH? Query measurement AH.
MEASure:KWH? Query measurement KWH.
MEASure:DCIR? Query measurement DCIR.
BATTery:SPEC:ALL? Query battery simulator specifications.
BATTery:ALL Set battery simulator all parameter values.
BATTery:ALL? Query battery simulator all the setting parameter values.
BATTery:OUTPut
Set battery simulator output status.
(0~2/OFF/PAUSE/CONTINUE)
BATTery:OUTPut?
Query battery simulator output status.
(OFF LINE/OFF/ON/PAUSE/PROGRAM)
BATTery:INITial
Set the battery simulator initial mode parameters. (0/Initial
CAP, 1/Initial VOL)
BATTery:INITial? Query battery simulator initial mode setting value.
BATTery:PARAmeter Set the battery simulator parameter to Ah or SOC.
BATTery:PARAmeter? Query battery simulator parameter to be Ah or SOC.
BATTery:INITial:CAP Set the battery simulator initial CAP parameters. Unit: %.
BATTery:INITial:CAP? Query battery simulator initial CAP setting value.
BATTery:INITial:VOLT Set the battery simulator initial VOL parameters. Unit: %.
BATTery:INITial:VOLT? Query battery simulator initial VOL setting value.
BATTery:CAP
Set the battery simulator CAP parameters. (float) Battery
pack total capacity; unit: Ah.
BATTery:CAP? Query battery simulator CAP setting value.
BATTery:OCP Set the battery simulator OCP parameters. (float)
BATTery:OCP? Query battery simulator OCP setting value.
BATTery:ESR
Set the battery simulator ESR parameters. (float) The range
is 1mΩ
～
1000mΩ .
BATTery:ESR? Query battery simulator ESR setting value.