Indicates thermal radiation emitted from the product
may cause burns.
This label warns of a cross-connection hazard when installing multiple
projectors at once. A fire hazard exists if a lamp power supply interlock
cable is connected to a different projector than its lamp power cables.
For more information, see Adjust the projector tilt and level in the
Installation and Setup chapter
Light intensity hazard distance
This projector has been classified as Risk Group 3 as per the IEC62471 standard due to possible
hazardous optical and thermal radiation being emitted.
Warning! Failure to comply with the following could result in serious injury.
•
PERMANENT/TEMPORARY BLINDNESS HAZARD! No direct exposure to the beam is permitted.
•
PERMANENT/TEMPORARY BLINDNESS HAZARD! Operators must control access to the beam
within the hazard distance or install the product at the height (greater than or equal to 3.0 m
from the floor to the beam) that prevents exposure of spectators' eyes within the hazard
distance.
•
EXTREME BRIGHTNESS! Do not place reflective objects in the product light path.
The following diagram and table shows the zones for optical and thermal radiation hazard distances:
A
B
A
B
•
Zone A—The light intensity may cause eye damage after a momentary or brief exposure
(before a person can avert his or her eye away from the light source). The light may cause
skin burns to occur.
•
Zone B—The light intensity does not pose a hazard due to the eye’s aversion response to bright
light. However, staring directly into the light may still be a hazard.
Introduction
Roadie 4K35 Quick Start Guide
9
020-101671-04 Rev. 1 (01-2016)
Copyright
©
2016 Christie Digital Systems USA Inc. All rights reserved.
