3. Place the shroud covers on a clean surface to prevent scratches.
Setting up the lens
Only use lenses designed for Roadie 4K35 projectors.
Warning! Failure to comply with the following could result in death or serious injury.
•
Keep fingers and other body parts away from the moving parts in the product. Tie back long
hair, and remove jewelry and loose clothing before manually adjusting the product.
•
The lens safety cable provided with the lens or service kit must be installed for overhead
installations.
Notice. Failure to comply with the following may result in property damage.
•
Do not operate the product without a lens installed.
1. Remove the projector shroud (on page 24).
2. Make sure the lens locking lever is in the up position.
3. If attached, remove the rear lens cap from the lens.
4. Slide the lens into the lens mount, aligning all connections.
Always install the lens with UP label in the top position to achieve consistent boresight
alignment each time the lens is replaced.
5. Secure the lens with the lens locking lever (down position).
6. Install the lens safety cable clamp and eyebolt.
7. Install the lens safety cable.
The lens safety cable is attached between the ring clamp on the lens and the eyebolt by
clipping the snap spring to the eyebolt.
Installation and Setup
Roadie 4K35 Quick Start Guide
25
020-101671-04 Rev. 1 (01-2016)
Copyright
©
2016 Christie Digital Systems USA Inc. All rights reserved.
