4. Once the required adjustment is made, tighten the lock nut against the bottom of the
projector (B).
The projector provides 27 mm of adjustment at the front and at the rear.
5. If the vertical or horizontal position of the projector requires more adjustment than the
standard feet allow, two 6-inch extension rods can be installed to increase the amount of
available adjustment.
Installing the foot extension rods
Increase the height of the projector with foot extension rods.
1. Elevate the rear of the projector to access the two rear feet.
2. Remove the feet by loosening the lock nut and rotating the each foot out of the projector.
3. Add the extension rods to the standard feet.
4. Thread the extended feet into the projector’s baseplate.
5. Adjust the feet until the required tilt is achieved.
6. Lock the feet in place by turning each lock nut until it fits tight against the projector.
Installing the touch panel controller
The touch panel controller (TPC) is a touch-sensitive screen. Use the touch panel controller to control
the projector, manage sources, adjust the display, and view status information.
1. Loosen the mounting arm just enough for the end to fit over the ball joint located on the rear
panel of the projector. The touch panel controller becomes loose from the mounting arm when
the mounting arm lock is loosened.
2. Tighten the mounting arm lock until it fits tightly on the joint.
3. Remove one of the M4 screws on the ball joint attached to the TPC.
Installation and Setup
Roadie 4K35 Quick Start Guide
23
020-101671-04 Rev. 1 (01-2016)
Copyright
©
2016 Christie Digital Systems USA Inc. All rights reserved.
