Resetting the lens to home position
Realign the lens to the home position after the lens has been offset and out of alignment.
1. Select LENS OFFSET.
You can also select MENU > Configuration > Lens Settings > Lens Offset.
2. To reset the lens to the default home position, select Enter.
3. To confirm the reset, select OK.
Adjusting boresight
The boresight adjustment balances the tilt of the lens mount to compensate for screen-to-projector
tilt.
Caution! If not avoided, the following could result in minor or moderate injury.
•
Do not look directly into the lens when the light source is on. The extremely high brightness can
cause permanent eye damage.
1. Close the shutter on the projector.
2. Unlock the three lens mount stabilization screws.
3. Open the shutter.
4. From the Test Pattern menu, select the Boresight test pattern.
The Boresight test pattern assists with adjusting the boresight for the three focus points.
Installation and setup
Mirage 304K (Bm.1) Installation and Setup Guide
28
020-102013-12 Rev. 1 (09-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Summary of Contents for Mirage 304K
Page 1: ...Installation and Setup Guide 020 102013 12 Mirage 304K Bm 1...
Page 68: ......