Lamp states
Learn the LED states of the lamp.
LED
State
Description
Off
Lamp is off.
On
Lamp is on.
Warming up
Lamp is warming up.
Cooling down
Lamp is cooling down.
Hours exceed user limit
Displayed if the user set a warning
level and the hours exceed it.
Failed to strike
Lamp failed to strike.
Lamp off - Unknown
Lamp is off but the state is unknown
because the lamp driver could not
be communicated with.
Lamp off - Interlock
Lamp is off due to an interlock being
triggered.
Missing
Lamp is not installed.
Turning off the projector
When powering off in preparation for inspection or maintenance, always disconnect from AC.
1. To turn the light source off using the projector keypad, press and hold the
button until you
hear a beep.
To turn off the light source using the remote, press and hold the OFF button until you hear a
beep.
When powering off the projector, allow the projector to complete its cool down cycle. Do not
immediately unplug the projector if this can be avoided.
2. To turn off power to the projector, disconnect from AC power.
Installation and setup
Mirage 304K (Bm.1) Installation and Setup Guide
25
020-102013-12 Rev. 1 (09-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Summary of Contents for Mirage 304K
Page 1: ...Installation and Setup Guide 020 102013 12 Mirage 304K Bm 1...
Page 68: ......
