OPERATION
DLV 1280 User's Manual
3-25
Src Key Mod
Choose how you want to select sources or channels when using the
key:
•
Switcher & Slot Location (default)
: Select this option if you have numerous
locations.
NOTE: The projector is always considered to be Switcher 0.
•
Pull-down list:
Select this option if you have numerous channels (source
setups) available and want to choose from a list accessed with the
key. The channel number, location (switcher and slot number) and sync
frequencies of each available channel will appear in the list (or, if a name
exists, the name will appear instead).
NOTE: The "In Menu" option in the Channel Setup menu must be turned
to “
On
” for any channel that you wish to see in the
key list.
•
2-digit channel:
Select this option if you have numerous channels (source
setups) available and want to change displays by pressing
and
entering a 2-digit channel number.
Keep in mind that a source number in the pull-down list identifies a particular
channel that has been set up and retained in projector memory. A source entered
as “switcher/slot” number identifies the physical location of the source.
Error Msgs
Choose in what way you want to be notified of errors detected in either the
incoming signal or projector. Select
Screen
or
All
if you want a brief message
displayed. If you prefer to be notified via an RS-232 message only, select
RS-232
instead. To disable error messages entirely (except invalid user entries), select
Off
.
NOTE: Display of invalid user entries cannot be disabled, even if you choose the
“
Off
” option.
DispSlideBr
If Display Slidebars is “
On
”, direct access slidebars can be superimposed over
the current image when an adjustable parameter is selected. These slidebars
include volume, contrast, brightness, position, pixel tracking and phase, and
others. If “
Off
”, slidebars will be invisible during adjustment.
Src Dialog
If you want to see on-screen feedback whenever you use the
key to switch
channels, set the Source Dialog box to “
On
”. A channel dialog box will then
prompt you to enter the switcher and slot location you want to use (if you have
set up this method of source selection in the Preferences menu).
If you would like to use the
key for “invisible” source/channel switching
(i.e., without a Source Dialog box reminder), set the Source Dialog box to “
Off
”.
You will still have to enter either the switcher and slot location after you press
, however no on-screen feedback will appear.
