7-16
D4K25 Service Manual
020-100880-01 Rev. 1 (06-2012)
Section 7: Serial API
NONE
Select measured color gamut for the current channel.
DATA
Set/Get active MCGD measurement values. The order is RedX, RedY, GreenX, GreenY, BlueX, BlueY,
WhiteX, WhiteY, BlackX, BlackY. The range for each value is 0 - 100000. The values represent MCGD
measurement values multiplied by 100000.
SAVE
Saves the active MCGD measurement values to a new or existing MCGD file. (SET Only Command)
EXAMPLES:
(MCG+C108 “Nominal”) Use file “Nominal” on channel 108
(MCG+C108?) Get measured color file name on channel 108
(MCG?L) List all entries of measured color control
(MCG+DATA 123 31786 00333 0 100000 66000 1 88899 2154 5441) Set the active MCGD measurement values to
RedX=0.00123,
RedY=0.31786, GreenX=0.00333, GreenY=0.00000, BlueX=1.00000, BlueY= 0.66000, WhiteX=0.00001, WhiteY=0.88899,
BlackX=0.02154, BlackY=0.05441
(MCG+DATA?) Retrieve the 10 active MCGD measurement values.
(MCG+SAVE “filename”) Save the 10 active MCGD measurement values to a file named “filename”. If the file doesn’t exist, it
will be created. If the file already exists, it will be overwritten.
MONITOR CARD CAGE FANS (MCF)
Enables or disables the monitoring of the two additional card cage fans.
SUBCODE
DESCRIPTION OF USE
NONE
Set to 1 to monitor and 0 to not monitor.
EXAMPLES:
(MCF 1) Start monitoring the card cage fans
CHANNEL NAME (NAM)
Set the descriptive channel name for the specified channel
SUBCODE
DESCRIPTION OF USE
Cxxx
Replace xxx with the channel number. Valid range is 101 - 164.
NONE
Select channel name for the current channel.
EXAMPLES:
(NAM+C108 “Scope 2.39”) Set channel name for channel 108
(NAM+C108?) Get channel name for channel 108
NETWORK SETUP (NET)
Set the network parameters for Eth0, Gateway, and Subnet 0.
SUBCODE
DESCRIPTION OF USE
DLP0
Set the IP address for the MGMT Ethernet controller (deprecated).
MEASURED COLOR (MCG) (CONTINUED)