Christie CC50-2301, Installation Manual

Page: 29 / 56

Section 2: Installation and Setup
CC50-2301/CC67-3001/CC72-3301 Installation Manual 2-19
020-100248-03 Rev. 1
8. Move the cables connecting the projector to the EM away from projector vents and the light path, and
secure to cable anchors.
Figure 2-22 Secured Projector Cables Viewed From Rear
9. Attach the spare cable anchor to the cube frame with 1 M6 cap screw, flat washer and 1 cable tie and
secure the projector power cable to the frame so that if the free end of the cable is pulled, the pressure is
applied against the cable anchor, not against the connection at the projector.
Figure 2-23 Power Cord, Anchored
2.2.9 Step 9 - Connect Sources
A variety of external sources can be connected to the input panel of the projector. Properly routing the cables
from one projector to another in the display wall will keep them from becoming tangled or falling into the
optical light path, affecting the displayed image. Each display cube enclosure is designed with two openings on
the side, two openings on the top, and channels in the belly pan to allow for source and power cables to be
easily routed. Cables can be routed across a row of display cubes and up the wall or from top to bottom,
starting in one corner. Whichever method you choose, maintain consistency across the wall until all projectors
are connected.
NOTE:
To prevent signal noise from power cables, separate power and signal cables where
possible. For example, route power cables vertically and signal cables horizontally.
4x Cable Ties