Christie CC50-2301, Installation Manual

Page: 23 / 56

Section 2: Installation and Setup
CC50-2301/CC67-3001/CC72-3301 Installation Manual 2-13
020-100248-03 Rev. 1
2.2.7 Step 7 - Install Display Screens
Tools and Hardware Required
• CC50 Screens: (4) M6 x 472mm screen bolts
• CC67 Screens: (4) M6 x 640mm screen bolts
• CC72 Screens: (4) M6 x 729mm screen bolts
• (8) M6 screws
• (4) M8 set screws
• For top row only, use two of the long screen bolts with (2) M6 x 60mm screws for each screen
• Torque wrench
• 10mm hex wrench or socket driver
• 5mm ball driver
• 4mm ball driver
NOTICES! 1)
Extend the two screen support set screws before installing a screen. This will ensure that the
weight of the screen is transferred to the pedestal/display cube below. Failure to do this can result in screens
bowing or damaging other screen elements. These screws can be used to set an even screen gap.
2)
Wear the
cotton gloves provided in the User’s Kit when handling screens to prevent leaving fingerprints on the surface.
3)
Install screens starting in the center of the bottom row and work out towards the ends. Repeat on the next
row, center screen first.
1. Add the 10 screen adjustment screws:
• 2 depth screws in each corner
• 2 height adjustment screws at the bottom
Install all adjustment screws so that they are flush with the inside surface of the screen frame. See
Figure 2-13 .
Figure 2-13 Install Depth Adjustments Screws
2. Starting with the centre cube, and working in pairs, lift the screen into position at the front of the display
cube. Ensure the screen is properly orientated with the two support screws at the bottom. The screws
should be fully extended. See
Figure 2-14 .