Christie CC50-2301, Installation Manual

Page: 17 / 56

Section 2: Installation and Setup
CC50-2301/CC67-3001/CC72-3301 Installation Manual 2-7
020-100248-03 Rev. 1
Figure 2-6 Pedestal Components and Mounting Locations
Constructing a PE50/PE67/PE72 Platform (Multiple Pedestals)
Refer to Figure 2-7 (panel #3) for correct screw location.
1. Slide two pedestals together aligning front and rear edges.
2. Using a level, adjust the pedestal feet until the two pedestals are level on all sides and with each other.
3. Inspect the inside corners of the pedestal to confirm that the pedestal feet remain fully engaged in the
pedestal. If you cannot see any threads at the top of the corner bracket where the foot is installed, then you
have over-extended the pedestal foot and must correct this before moving on.
4. Loosely fasten the two pedestals together using 4 M6 x 75mm hex screws, 8 flat washers, 4 lock washers,
and 4 M6 hex nuts. Keeping the hardware a little loose at this point will allow you to tweak the alignment
between pedestals as more pedestals are added to the platform.
5. Slide the next pedestal into position and, using a level, adjust the height until the pedestal becomes level
with the pedestals already in the row.
6. Repeat steps 3 to 5, for each additional pedestal.
7. Confirm that the platform is level and that all rear edges between pedestals are flush.
8. Tighten the loose hardware to secure the pedestals in place.
9. Verify that the entire platform structure is level.
NOTICE!
Apply downward pressure on the pedestal to ensure that the feet are flat to the floor.
A
B
B
B
B
A
A
D
E
A
C
C
A
Use to fasten pedestals together, (4)
on each side panel
B
Use to install display cubes, (2) at
the back and (2) at the front
C
On PE67/PE72 pedestals only, use
to install display cubes, (2) on sup-
port bracket.
D
Front Panel
E
Adjustable foot (4)