Section 3: Operation
3-52
Mirage S+/HD, Matrix S+/HD, Christie HD/DS+/DW, DLV User Manual
020-100001-05 Rev. 1 (12-2008)
characteristics of each motor and values are saved in the projector’s memory. If ILS
™
is enabled and a
motion calibration
has previously been done, the projector will
automatically recall these settings from memory when it’s being powered up and a
motion
calibration
will not take place. A
full
calibration
performs both a
reference
and
motion
calibration.
Automatic ILS Lens Calibration
When this option is selected (default) and the projector is in ILS mode, the projector
will perform a lens calibration on each power-up. During calibration, the shutter will
be closed and the status LED will display ‘LC’. If ILS is not selected, the ALC setting
will be ignored. If, during power-up, ALC is not selected and ILS is, the last stored
location from the previous ILS calibration will be assumed to be true and the lens will
moved to that position upon power-up if necessary.
The two “Option Card”
entries In the
Configuration
menu
identify which optional
input modules (a.k.a.
cards
) are present at
INPUT 5
(Option 1) and
INPUT 6
(Option 2). If
either of these option
slots is empty, the
corresponding read-only menu entry does nothing. If there is a module installed, the
corresponding menu entry may activate a submenu of further options pertaining to
that module.
For example, if the
Dual SD/HD-SDI
module is installed at
INPUT 5
(Option 1). The
Option 1 Card submenu provides controls for configuring the various connections on
this multi-input, multi-output module. As desired for your application, you can define
1) which physical input loops through to which output, and 2) which functional input
(main or PIP signal) loops through to which output.
Select Automatic mode or a series of
manual modes. In Automatic mode
the input video payload information
is read and compared to that of the
SMPTE 352 standard to detect the
dual link format and the primary
channel. Single video input will also
work in this mode without any
payload information. Dual link input
video which does not contain payload
information must be set up manually.
Select the format and which of the
two channels is the primary input.
Input A to C, Input B to D
Input A to D, Input B to C
Main to C, PIP to D
Main to D, PIP to C
1.
2.
3.
4.
Loop Thru Output Selection
Configure Channels
1.
2.
Option Card 1: Dual SD/HD-SDI Module
Input A to C, Input B to D
Automatic
System
Configuration
OPTIONAL INPUT MODULES
System Configuration
CONFIGURE CHANNELS -
SUBMENU
Automatic
Two Single Channels
4:4:4 RGB Dual Link, Channel A Primary
4:4:4 RGB Dual Link, Channel B Primary
4:4:4 YCbCr Dual Link, Channel A Primary
4:4:4 YCbCr Dual Link, Channel B Primary
1.
2.
3.
4.
5.
6.