Section 3: Operation
3-42
Mirage S+/HD, Matrix S+/HD, Christie HD/DS+/DW, DLV User Manual
020-100001-05 Rev. 1 (12-2008)
Figure 3.8. Using the “Network Routing” Option
RS232 AND RS422 JOINED:
Messages originating from an RS232 or RS422 controller
will be relayed to all RS232or RS422 ports. Any Ethernet communication, however,
will not.
RS232 AND ETHERNET JOINED:
Messages to and from the RS232 ports will also be
relayed to the Ethernet port, and vice versa. Any RS422 communications will be
isolated.
ALL JOINED:
All messages reach all ports, regardless of type.
Ethernet Settings
(SUBMENU)
NOTE:
Recommended for network administrators only.
DHCP:
Enable this checkbox if you want a DHCP server to automatically change the
projector’s default IP address (0.0.0.0) to one that is valid and unique for use on the
current Ethernet network. On networks without a DHCP server, or to simply override
the automatic DHCP server function, delete the checkmark and enter the new “IP
Address” settings desired. Remember that only a 0.0.0.0 address will trigger the
DHCP addressing service, and only when the DHCP checkbox is enabled.
IP ADDRESS:
Enter a valid and unique IP address for use on the network to which the
projector is currently connected. This address will overwrite any previous IP address
such as the projector’s factory-defined default (0.0.0.0), or one that has been assigned
by a DHCP server or other user. It takes approximately 10 seconds for the projector to
respond at its new address.
