Section 3: Operation
3-50
Mirage S+/HD, Matrix S+/HD, Christie HD/DS+/DW, DLV User Manual
020-100001-05 Rev. 1 (12-2008)
Color Enable
Select which color or colors you want to see. This is useful while working with color
temperature, input levels or other special setup parameters. Colors can also be
enabled/disabled by entering the corresponding function code listed on the back of the
standard remote keypad.
Odd Pixel Adjustment
NOTES:
1)
Factory-set and rarely required by user.
2)
Source must be >90 MHz.
When using certain RGB sources, you may need to adjust the normal gain or offset of
odd pixels in relation to even pixels. This will smooth out very narrow (one-pixel
wide) “checks” or vertical stripes that indicate adjacent “on” and “off” pixels. Using
the Level Detector simplifies this process (see Figure 3.12):
1.
Use an external analog native-sized continuous grayscale test pattern with at least
256-levels.
2.
Turn “Level Detector” on.
3.
Set “Level Value” to
~200
. The image should now be black-and-white (or black-
and-one color, if you use “Color Enable” function).
4.
Adjust
offset
. Half of the pixels will move, the other half will not.
5.
Adjust until the two transition regions overlap. The stripe of noise will be
minimized, defined by the value in the slide bar.
6.
Set “Level Value” to
~800
. The image should now be black-and-white.
7.
Repeat Steps 4 and 5, but adjusting
gain
.
8.
Repeat Steps 3-7 for all remaining colors. Your RGB source should now be OK.
Two sets of values are automatically saved with these controls—one value for Input
#1, and one for Input #2 (analog). The current set of values depends on which source
is in use. This enables a source to be processed correctly via two different inputs.
1.
2.
3.
4.
5.
6.
7.
8.
9.
0.
Red Odd Pixel Offset
Green
Blue
Red Odd Pixel Gain
Odd Pixel Offset
Green Odd Pixel Gain
Odd Pixel Offset
Blue Odd Pixel Gain
Level Detector
Level Value
Auto Color Enable
Color Enable
Input Levels
Odd Pixel Adjustment
128
145
128
128
116
128
200
White
Set to ~ 200
& adjust Offset.
Set to ~ 800
& adjust Gain.
Figure 3.12. Using “Odd Pixel Adjustment”
NOTES:
1)
Adjust offset before gain, since offset affects gain.
2)
A value of 128
represents no change in normal odd pixel offset or gain.
3)
Odd Pixel Adjustment
eliminates “one pixel on, one pixel off” artifact only, not any type of larger artifacts.
Reserved -
No function.
