24
The forklift used must have sufficient carrying capacity (at least 10 tons).
The prong of the forklift used should be at least 1634mm long.
Insert the prong into the fork pockets at the bottom of the container. The position of the fork
pockets is shown below. The prong should be at least 1634mm long to carry the container.
During handling, please handle the unit slowly and steadily. Be sure to perform trial handling
first.
The place should be firm and flat, with good drainage and no obstacles or humps. The
container should be placed and supported by the four bottom fittings.
Danger
Container front view
Figure 5-3 Position of forklift hole
WARNING:
The fork pockets must be used to handle the container.
Under no circumstance should the container be handled by directly inserting the
prong below the bottom of the container.
NOTE:
The slots and the container interior have already been sealed properly. There is no need
to seal the slots after the field installation.
5.4 Foundation
5.4.1 Selection of Installation Site
When selecting the installation site, consider at least the following requirements:
Ambient and geological conditions, like stress wave emissions, the level of underground
water table and etc. should be taken into account.
The ambient environment should be dry, well ventilated, and far away from inflammable
materials.
The ground at the installation site must be compacted enough. Relative compaction of the
ground should be equal or greater than 98%.take proper methods to strengthen the ground if
otherwise.
