Installation Instructions
TIL1X2PT / TIL1X3PT / TIL1X4PT / TILVABPT
7
IMPORTANT ! :
Refer to
Fastener Installation Methods
(located in
Appendix
at end of Installation Instructions)
for details on installing product into various wall types.
4.
Partially install two lag screws into wall, but do NOT
completely tighten to wall. (See Figure 7)
NOTE:
(OPTIONAL)
If more LED screens need to be added to
the top or bottom of the screen configuration, add
TILVABPT vertical connector kit (not included) to top or
bottom of wall mount following instructions in the
(OPTIONAL) Adding Vertical Connector Kit
. If you
are NOT adding the TILVABPT connector kit, proceed
to
Step 5
.
Figure 7
5.
Hang wall mount, aligning upper mounting slots over
fasteners, and adjust side-to-side for proper location, but do
NOT completely tighten to wall. (See Figure 7)
6.
Place a level across front of the mount at bottom of teardrop
slots. (See Figure 8)
7.
Check the level of the mount at the teardrop slots. (See
Figure 8)
Figure 8
8.
Slide the left (A-Left) and right (A-Right) adjustment washers
into place behind the partially installed lag screws. (See
Figure 9)
Figure 9
9.
Check the level of the mount at the bottom of the teardrop
slots. (See Figure 10)
10. If the mount is not level, slide or use a dead blow hammer
to lightly tap the spacer into place. This will lift the mount up
as the lag screw rides in the washer’s angled slot. (See
Figure 10)
11. When the mount is leveled, tighten the lag screws (C). (See
Figure 10)
Figure 10
5
x 2
4
7
Mount
teardrop
Levels
slots
6
8
A (right)
A (left)
Just a tip -
Tighten down the lag screw on the
side that does
NOT
need to be raised. This
creates a pivot point for when the opposite
adjustment washer is tapped into place, and
allows that correct side of the mount to move up.
Level
Dead blow
hammer
11
(C) x 2
9
10